PID Gas Sensor Principle | How Photoionization PID VOC Sensor Works

classify:PID sensor   time:2026-11-04

What is a PID Gas Sensor

PID stands for Photoionization Detector. A PID gas sensor is a high-sensitivity gas sensor widely used to detect VOCs (Volatile Organic Compounds) and TVOC. It supports trace gas measurement down to ppb level, and is popular for industrial leak inspection, environmental air monitoring, IAQ testing and hazardous gas emergency detectionWinsen Ele....

Working Principle of PID Sensor

PID works based on the photoionization effect. Inside the ionization chamber is an ultraviolet lamp, commonly 10.6 eV, also available in 10.0 eV and 11.7 eV versions. The UV lamp emits high-energy photons.

When sample gas flows into the chamber, gas molecules will absorb UV photons and be ionized only if their ionization potential is lower than photon energy. Molecules split into positive ions and free electrons: RH + hν → RH⁺ + e⁻.

An electric field is applied between two collecting electrodes. Positive ions drift toward the cathode while free electrons move to the anode. This movement generates a tiny ion current.The ion current is directly proportional to the amount of ionized molecules, namely VOC concentration. The signal circuit amplifies the weak current and converts it into readable concentration in ppm or ppb units.

One key feature: PID detection is non-destructive. After leaving the electric field, ions recombine back into original gas molecules. The sample gas is not consumed or chemically changed permanently.

Main Components of PID Sensor

  1. UV lamp: photon source; its energy decides detectable gas types;
  2. Ionization chamber: the space where photoionization takes place;
  3. Collecting electrodes: capture ions and electrons to form current;
  4. Signal processing circuit: amplify weak current, filter noise and calculate gas concentration;
  5. Inlet filter membrane: block dust and reduce humidity interference.

Detectable & Undetectable Gases

✅ Detectable: Benzene, toluene, xylene, acetone, ethyl acetate, isopropanol and most VOCs, plus a few inorganic gases like hydrogen sulfide and phosphine.❌ Not detectable: N₂, O₂, CO₂, methane and water vapor. Their ionization potential exceeds 10.6 eV and cannot be ionized by standard PID lamps.

Advantages and Limitations

Advantages: Ultra-fast response, high sensitivity, ppb-level resolution, ideal for rapid leak survey.Limitations: Poor gas selectivity; it cannot tell which specific VOC is present. Humidity may cause interference. The UV lamp is a consumable part with limited service life.

Typical Applications

Chemical plant leak detection, hazardous material emergency response, gasoline vapor monitoring, indoor TVOC air quality test, site screening for soil & groundwater organic pollution, coating workshop exhaust monitoring.