What is the light source of PID sensorThe PID sensor light source is a vacuum ultraviolet (VUV) UV lamp. It is the most critical consumable part inside the PID sensor. Whether a VOC can be detected is determined by the photon energy (eV) emitted by the UV lamp. The UV lamp provides high-energy photons to ionize gas molecules. Without the UV light source, the PID cannot measure VOCs.
Structure and working mechanism of PID UV lampThe lamp is a sealed glass tube filled with low-pressure special gas (krypton, argon etc.). The light window is made of special single crystal material such as magnesium fluoride (MgF₂) or lithium fluoride (LiF). Ordinary quartz glass cannot transmit vacuum UV light at this wavelength. The driving circuit supplies high voltage to trigger glow discharge inside the tube and produce vacuum UV photons of fixed energy. The lamp glows bluish violet to human eyes, but the visible light does not contribute to ionization. Only vacuum UV photons can ionize VOC molecules.
Main types of PID UV lamps10.6 eV (Most widely used) MgF₂ window, krypton fill gas. Detects most common VOCs for coating, printing, indoor TVOC and industrial leak survey. Long service life over 10,000 hours for continuous operation. It is the standard lamp for most PID modules.
9.8 eV / 10.0 eV (Selective detection) Lower photon energy. Only ionizes compounds with low ionization potential. Good response to benzene series and suppress interference from many other solvents. Mainly used for benzene-specific monitoring and occupational hygiene testing, with narrower detectable range.
11.7 eV (High-energy lamp) LiF window, argon fill gas. Covers more compounds including some halogenated organics that cannot be detected by 10.6 eV lamps. Drawbacks: LiF crystal is sensitive to moisture and UV degradation, short lifespan and higher cost, only for special applications.
Common notes for PID light sourceIt is a consumable and decays gradually. UV intensity drops over time, causing reduced sensitivity and baseline drift; lamp replacement is required eventually.
Contamination by moisture, oil mist and dust on the crystal window blocks UV transmission and leads to low readings.
Lamps stored for a long time may be hard to ignite at first startup.
Selection rule: Ionization potential of target gas < lamp photon energy.
Quick selection guide for PID UV lampGeneral VOC / TVOC / solvent leak inspection → 10.6 eV
Benzene dedicated measurement, reduce cross interference → 9.8 eV /10.0 eV
Detect certain high-ionization-energy halogenated organics → 11.7 eV
PID Sensor Light Source | Vacuum UV Lamp Specifications, Selection and Lifespan
classify:PID sensor time:2026-11-04
BIKAI Technology Co., Ltd.